Razormage's Glaun - WiP
Posted: Mon Jul 22, 2013 1:38 pm
I've delayed putting anything up on here, because I hadn't managed to get paint on any of my Mierce Miniatures until last night. Now that I've done it, I'm excited enough that I want to put up some WiPs, even though I usually avoid doing that as much as possible, because I'm never satisfied until it's all done!
This is pretty much just a picture dump; if you want the full commentary, or want to see some my other non-Mierce stuff, feel free to check out my blog at http://thebeerwaaagh.blogspot.com.
First off, some shots of it assembled but unprimed...
His left wing came slightly bent from the Texas heat. Rather than fix it, I've left it, as I feel it adds a bit more motion to that otherwise static arm.
Primed black, and first base coat on the skin in place:
Second layer of skintone:
Third layer:
Fourth layer:
I have probably three or four layers to go on the skintone, then I'll move on to the scales/horns, and finally the mouth.
This is pretty much just a picture dump; if you want the full commentary, or want to see some my other non-Mierce stuff, feel free to check out my blog at http://thebeerwaaagh.blogspot.com.
First off, some shots of it assembled but unprimed...
His left wing came slightly bent from the Texas heat. Rather than fix it, I've left it, as I feel it adds a bit more motion to that otherwise static arm.
Primed black, and first base coat on the skin in place:
Second layer of skintone:
Third layer:
Fourth layer:
I have probably three or four layers to go on the skintone, then I'll move on to the scales/horns, and finally the mouth.